Husqvarna 966451906 用户手册

English - 

33

Repair Instructions

Assemble the intake system.

Fit the lower screws of the intake system using the 

POP-out hole and the fuel hose hole. Fit the other 

screws. Fit the fuel hose and the throttle cable to 

their attachments. See figure 24. 

Fit the rubber grommet to the throttle cable. Push 

the tank back in position. Hook on the cabling to 

the holder on the intake system.

NOTE! Press the lug on the carburettor in place on 

its bracket on the partition wall. See figure 24. 
Fit the carburettor, the filter holder and the air filter 

as outlined in “Assembling the carburettor”.

Clean and check all parts carefully. Parts must 

be replaced if cracked or showing signs of other 

defects. Always use original spare parts.

Dismantle the air filter, the filter holder, the cable 

from the intake flange holder and the carburettor 

and the throttle cable as outlined in “Dismantling 

the carburettor”. NOTE! The lug on the carburettor 

sits on the bracket on the partition wall.

Hook off the cabling from the holder on the intake 

system (J). Knock out the POP-out window using a 

screwdriver. See figure 25. Lower the tank slightly 

and slide the fuel hose down into the hole. Loosen 

the lower screws of the intake system using the 

POP-out hole and the fuel hose hole. Loosen the 

other screws.

 

Dismantle the intake system. Pull up and then out-

ward. See figure 26.

Fig 24

Fig 25b

Fig 26

Fig 25a