Husqvarna 336 EPA I 用户手册

English

 – 19

Starting: The chain brake should be activated when starting 
the chain saw. Activate the chain brake by pushing the front 
hand guard forwards.

Ignition: Set the stop switch to the start position.

Choke: Set the choke control in the choke position.

Primer bulb: Press the air purge repeatedly until fuel begins 
to fill the bulb. The bulb need not be completely filled.

Use the same procedure as for starting a cold engine but 
without setting the choke control in the choke position. The 
correct choke/start throttle setting is obtained by moving the 
choke control to the choke position and then pushing it in 
again.

Grip the front handle with your left hand. Hold the chain saw 
on the ground by placing your right foot through the rear 
handle. Pull the starter handle with your right hand and pull 
out the starter cord slowly until you feel a resistance (as the 
starter pawls engage) then pull firmly and rapidly. Never wrap 
the starter cord around your hand

CAUTION! Do not pull the starter cord all the way out and do 
not let go of the starter handle when the cord is fully extended. 
This can damage the machine.

Slide the control to its start throttle position when the engine 
fires and make repeated attempts until the engine starts. 
When the engine starts, quickly apply full throttle to 
automatically disengage fast idle.

As the chain brake is still activated the engine must return to 
idling speed as soon as possible by disengaging the throttle 
latch in order to avoid unnecessery wear on the clutch 
assembly.