Husqvarna BC2145 用户手册

24 – English

engine to idle, press the throttle lockout and throttle trigger 
again.

Start throttle: (FC 2145, FC 2145 S, FC 2145 W, BC 
2145, CC 2145)

Set the throttle to the start position by moving the choke 
control to the choke position and then returning it to its 
original position.

If the machine is fitted with a decompression valve (A): 
Press the valve to reduce the pressure in the cylinder and 
make starting easier. You should always use the 
decompression valve when starting the machine. Once 
the machine has started the valve will automatically return 
to its original setting.

Hold the body of the machine on the ground using your 
left hand (CAUTION! Not with your foot!). Grip the starter 
handle, slowly pull out the cord with your right hand until 
you feel some resistance (the starter pawls grip), now 
quickly and powerfully pull the cord. Never twist the 
starter cord around your hand.

Repeat pulling the cord until the engine starts. When the 
engine starts. return choke control to run position and 
apply full throttle; the throttle will automatically disengage 
from the start setting.

CAUTION!  Do not pull the starter cord all the way out and 
do not let go of the starter handle when the cord is fully 
extended. This can damage the machine.

Stop the engine by switching off the ignition.

Models equipped with heating elements in the handles 
have an on/off switch on the throttle handle to control the 
heat. Both the left and right handles have heating 
elements that automatically maintain a temperature of 
roughly 70

° when the heat is turned on.