Husqvarna 365 EPA I 用户手册

English

 – 37

On models with the designation XPG/G, the front as well as 
the rear handle are equipped with electric heating coils. 
These are fed with electrical current from an integrated 
generator in the chain saw.

When the red mark on the switch is visible, the heating is on.

On models with the designation CARBURETOR HEATING 
there is an electrically heated carburetor. Electrically powered 
heating prevents ice formation in the carburetor. A thermostat 
regulates the heating so that the carburetor always has the 
right working temperature.

If this chain saw has the model code XPG/G then it is 
equipped with an electrically heated carburettor. The 
electrical heating prevents icing in the carburettor. A 
thermostat regulates heating so that the carburettor always 
has the correct working temperature.

The carburettor heater is used in the following temperature 
range: 

±0ºC or colder. During high humidity, icing of the 

carburettor can occur earlier than specified.

The carburettor heater only heats the carburettor when the 3-
way switch is set to position ”II”.

The switch is off in position ”0”, supplies current to the handle 
heater in position ”I”, supplies current to the carburettor in 
position ”II”.

CAUTION! The carburettor heater reaches maximum 
temperature after about 3 minutes. It is therefore important 
that the machine is not run for longer with the heater switched 
on. If the switch is left on for too long the carburettor will 
overheat and lead to running problems or starting problems.