Husqvarna 353G E-tech 用户手册
GENERAL SAFETY PRECAUTIONS
16 – English
•
Check that the bar tip sprocket turns freely and that
the lubricating hole in the tip sprocket is not blocked.
Clean and lubricate if necessary.
the lubricating hole in the tip sprocket is not blocked.
Clean and lubricate if necessary.
If the chain lubrication system is still not working after
carrying out the above checks and associated measures
you should contact your servicing dealer.
carrying out the above checks and associated measures
you should contact your servicing dealer.
Chain drive sprocket
The clutch drum is fitted with one of the following drive
sprockets:
sprockets:
A Spur sprocket (the chain sprocket is welded on the
drum)
drum)
B Rim sprocket (replaceable)
Regularly check the degree of wear on the drive sprocket.
Replace if wear is excessive. Replace the drive sprocket
whenever you replace the chain.
Replace if wear is excessive. Replace the drive sprocket
whenever you replace the chain.
Needle bearing lubrication
Both versions of sprockets have a needle bearing on the
drive shaft, which has to be greased regularly (once a
week). CAUTION! Use only high quality bearing grease or
engine oil.
drive shaft, which has to be greased regularly (once a
week). CAUTION! Use only high quality bearing grease or
engine oil.
See instructions under the heading Maintenance, Needle
bearing lubrication.
bearing lubrication.
Checking wear on cutting equipment
Check the chain daily for:
•
Visible cracks in rivets and links.
•
Whether the chain is stiff.
•
Whether rivets and links are badly worn.
Replace the saw chain if it exhibits any of the points
above.
above.
We recommend you compare the existing chain with a
new chain to decide how badly the existing chain is worn.
new chain to decide how badly the existing chain is worn.
When the length of the cutting teeth has worn down to
only 5/32 inch (4 mm) the chain must be replaced.
only 5/32 inch (4 mm) the chain must be replaced.
Bar
Check regularly:
•
Whether there are burrs on the edges of the bar.
Remove these with a file if necessary.
Remove these with a file if necessary.
•
Whether the groove in the bar has become badly
worn. Replace the bar if necessary.
worn. Replace the bar if necessary.
•
Whether the tip of the bar is uneven or badly worn. If
a hollow forms on the underside of the bar tip this is
due to running with a slack chain.
a hollow forms on the underside of the bar tip this is
due to running with a slack chain.
•
To prolong the life of the bar you should turn it over
daily.
daily.
!
WARNING! Most chain saw accidents happen
when the chain touches the operator.
when the chain touches the operator.
Wear personal protective equipment. See
instructions under the heading ”Personal
protective equipment”.
instructions under the heading ”Personal
protective equipment”.
Do not tackle any job that you feel you are not
adequately trained for. See instructions under
the headings Personal protective equipment,
How to avoid kickback, Cutting equipment
and General working instructions.
adequately trained for. See instructions under
the headings Personal protective equipment,
How to avoid kickback, Cutting equipment
and General working instructions.
Avoid situations where there is a risk of
kickback. See instructions under the heading
Machine
kickback. See instructions under the heading
Machine
′′′′
s safety equipment.
Use the recommended protective equipment
and check its condition. See instructions
under the heading General working
instructions.
and check its condition. See instructions
under the heading General working
instructions.
Check that all the chain saw safety features
are working. See instructions under the
headings General working instructions and
General safety precautions.
are working. See instructions under the
headings General working instructions and
General safety precautions.