Husqvarna CARB III 用户手册
GENERAL SAFETY PRECAUTIONS
English
–
15
115 13 80-96 Rev.3 2008-12-17
435
•
Loosen the bar nut that holds the clutch cover and
chain brake. Use the combination spanner. Then
retighten the bar nut as tightly as you can by hand.
chain brake. Use the combination spanner. Then
retighten the bar nut as tightly as you can by hand.
•
Raise the tip of the bar and stretch the chain by
tightening the chain tensioning screw using the
combination spanner. Tighten the chain until it does
not sag from the underside of the bar.
tightening the chain tensioning screw using the
combination spanner. Tighten the chain until it does
not sag from the underside of the bar.
•
Use the combination spanner to tighten the bar nut
while holding up the tip of the bar. Check that you can
pull the saw chain round freely by hand, and that there
is no slack on the underside of the bar.
while holding up the tip of the bar. Check that you can
pull the saw chain round freely by hand, and that there
is no slack on the underside of the bar.
The position of the chain tensioning screw on our chain
saws varies from model to model. See instructions under
the heading What is what? to find out where it is on your
model.
saws varies from model to model. See instructions under
the heading What is what? to find out where it is on your
model.
435e, 440e
•
Release the knob by folding it out.
•
Turn the knob anti clockwise to loosen the bar cover.
•
Adjust the tension on the chain by turning the wheel
down (+) for tighter tension and up (-) to loosen the
tension.
down (+) for tighter tension and up (-) to loosen the
tension.
•
Tighten the bar clutch by turning the knob clockwise.
•
Fold the knob back in to lock the tensioning.