Husqvarna 324LX-Series 用户手册

12 – 

English

•

Clip the loop handle onto the shaft. Note that the loop 
handle must be fitted between the arrows on the shaft.

•

Slide the spacer into the slot in the loop handle.

•

Fit the nut, knob and screw. Do not overtighten.

•

Now adjust the trimmer to give a comfortable working 
position. Tighten the bolt/knob.

•

Make sure the knob is loose.

•

Align the cut-out in the lower part of the shaft with the 
coupling locking tab on the upper part of the shaft. Then 
lock the sections together.

•

Tighten the knob.

•

Undo the knob (at least three turns).

•

Push the knob towards the coupling.

•

Carefully twist the lower half of the shaft to unlock it.

•

Hold both parts of the shaft and pull the lower part of the 
shaft out of the coupling.

•

Fit the correct trimmer guard (A) for use with the trimmer 
head. Hook the guard onto the fitting on the shaft and 
secure it with the bolt (L).

•

Fit the drive disc (B) on the output shaft.

•

Turn the blade shaft until one of the holes in the drive disc 
aligns with the corresponding hole in the gear housing.

•

Insert the locking pin (C) in the hole to lock the shaft.

•

To fit the trimmer head, first separate the two halves (see 
diagram). Proceed as follows:

•

Insert a finger into the centre hole of the cover (I) while 
grasping the cover with your other fingers. Using the index 
finger and thumb of your other hand, release the two 
catches (J) that engage in the cut-outs in the bottom half 
(K). Pull apart the trimmer head, grasping the cover firmly.

•

Place the cover (I) and the support flange (F) on the 
output shaft. Ensure that the drive discs guide locates 
correctly in the covers centre hole.