Husqvarna T435 用户手册

English

 –

 11

The only way to avoid kickback is to make sure that the 
kickback zone of the bar never touches anything.

By using cutting equipment with ”built-in” kickback 
reduction and keeping the chain sharp and well-
maintained you can reduce the effects of kickback.

The smaller the tip radius the lower the chance of 
kickback.

A chain is made up of a number of links, which are 
available in standard and low-kickback versions.

To maintain the safety features of the cutting equipment, 
you should replace a worn or damaged bar or chain with 
a bar and chain combinations recommended by 
Husqvarna. See instructions under the heading Technical 
Data for a list of replacement bar and chain combinations 
we recommend.

•

Length (inches/cm)

•

Number of teeth on bar tip sprocket (T).

•

Chain pitch (inches). The spacing between the drive 
links of the chain must match the spacing of the teeth 
on the bar tip sprocket and drive sprocket.

•

Number of drive links. The number of drive links is 
determined by the length of the bar, the chain pitch 
and the number of teeth on the bar tip sprocket.

•

Bar groove width (inches/mm). The groove in the bar 
must match the width of the chain drive links.

•

Chain oil hole and hole for chain tensioner. The bar 
must be matched to the chain saw design.

•

Chain pitch (inches)

•

Drive link width (mm/inches)

•

Number of drive links.

•

Never use a blunt chain. When the chain is blunt you 
have to exert more pressure to force the bar through 
the wood and the chips will be very small. If the chain 
is very blunt it will produce wood powder and no chips 
or shavings.

•

A sharp chain eats its way through the wood and 
produces long, thick chips or shavings.

IMPORTANT! No saw chain design eliminates the 
danger of kickback.