Husqvarna T435 用户手册

32 – English

Regularly check that the muffler is securely attached to 
the machine.

Loosen the screws (1 and 2).

Push the muffler cover as shown in the picture.

Loosen the screws and nuts. Remove and check that the 
muffler is ok.

The muffler is designed to reduce the noise level and to 
direct the exhaust gases away from the operator. The 
exhaust gases are hot and can contain sparks, which may 
cause fire if directed against dry and combustible 
material.

The muffler is equipped with a special spark arrestor 
mesh. The spark arrestor mesh should be cleaned once a 
month. This is best done with a wire brush. A blocked 

mesh will cause the engine to overheat and may lead to 
serious damage.

Note! The mesh must be replaced if it is damaged. If the 
mesh is blocked the machine will overheat and this will 
cause damage to the cylinder and piston. Never use a 
machine with a muffler that is in poor condition. Never 
use a muffler if the spark arrestor mesh is missing or 
defective.

•

Loosen the screws that hold the starter against the 
crankcase and remove the starter.

•

Pull out the cord approx. 30 cm and hook it into the 
notch in the rim of the pulley. Release the recoil spring 
by letting the pulley rotate slowly backwards.