Husqvarna 1151439-95 用户手册

18 – 

English

Starting: The chain brake should be activated when starting 
the chain saw. Activate the chain brake by pushing the front 
hand guard forwards.

Ignition; choke: Slide the control to its rear position.

Primer bulb: Press the air purge repeatedly until fuel begins 
to fill the bulb. The bulb need not be completely filled.

Use the same starting procedure as for a cold engine, with the 
following exceptions:

•

Slide the control to its rear position.

•

Slide the control back to its middle position (working 
position).

Grip the front handle with your left hand. Hold the chain saw 
on the ground by placing your right foot through the rear 
handle. Pull the starter handle with your right hand and pull 
out the starter cord slowly until you feel a resistance (as the 
starter pawls engage) then pull firmly and rapidly. Never wrap 
the starter cord around your hand

CAUTION! Do not pull the starter cord all the way out and do 
not let go of the starter handle when the cord is fully extended. 
This can damage the machine.

Push in the choke control as soon as the engine fire and make 
repeated starting attempts. Immediately press and release 
the throttle when the engine starts. That will disengage the 
throttle latch.

As the chain brake is still activated the engine must return to 
idling speed as soon as possible by disengaging the throttel 
latch in order to avoid unnecessery wear on the clutch 
assembly.

Note! Pull the front hand guard towards the front handle. The 
chain brake is now disengaged. Your saw is ready for use.

•

Never start a chain saw unless the bar, chain and all 
covers are fitted correctly. See instructions under the 
heading Assembly. Without a bar and chain attached to 
the chain saw the clutch can come loose and cause 
serious injury.