Jonsered 70C 用户手册
English
– 37
TECHNICAL DATA
Recommended original and replacement bar and chain combinations
These Husqvarna chain saw models are in the ANSI category of saws above 3,8 cu. in. and are not required to comply with low
kickback performance requirements. However, for these models we recommend the following cutting equipment.
kickback performance requirements. However, for these models we recommend the following cutting equipment.
Note: For the chains above you are free to choose between 0,050", 0,058" and 0,063" gauge drive link for the corresponding bar,
see the table below.
see the table below.
Bar
Chain
Length, inches
Pitch, inch
Max nose radius
16
3/8
11T
Jonsered S42, Oregon 73LP/73LG
18
3/8
11T
Jonsered S42, Oregon 73LP/73LG
20
3/8
11T
Jonsered S42, Oregon 73LP/73LG
24
3/8
11T
Jonsered S42, Oregon 73LP/73LG
28
3/8
11T
Jonsered S42, Oregon 73LP/73LG
0,050"/1,3 mm
72LP
72LG
72V
0,058"/1,5mm
S42/73LP
73LG
73V
0,063"/1,6 mm
75LP
75LG
75V
!
WARNING! This chain saw model is capable of severe kickback that could result in serious injuries to the
user. Do not operate this saw unless you have extraordinary cutting needs and experience and specialized
training for dealing with kickback. Saws with significantly reduced kickback potential are available. Always
use the safest saw and cutting equipment applicable to your cutting need.
user. Do not operate this saw unless you have extraordinary cutting needs and experience and specialized
training for dealing with kickback. Saws with significantly reduced kickback potential are available. Always
use the safest saw and cutting equipment applicable to your cutting need.
D
2
L
_
D
PITCH =