Husqvarna 525 RS 用户手册
ASSEMBLY
12 – English
Fitting the loop handle (524 L, 525
LST, 525 RJD)
LST, 525 RJD)
•
Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
handle must be fitted between the arrows on the shaft.
•
Slide the spacer into the slot in the loop handle. Fit the
nut, knob and screw. Do not overtighten.
nut, knob and screw. Do not overtighten.
•
Now adjust the trimmer to give a comfortable working
position. Tighten the bolt.
position. Tighten the bolt.
Fitting the handlebar (525 RS)
•
Remove the screw at the rear of the throttle handle.
•
Slide the throttle handle onto the right side of the
handlebar, (see diagram).
handlebar, (see diagram).
•
Align the screw hole in the throttle handle with the hole
in the handlebar.
in the handlebar.
•
Refit the screw in the hole in the rear of the throttle
handle.
handle.
•
Screw the screw through the handle and handlebar.
Tighten it.
Tighten it.
•
Unscrew the knob from the handlebar mounting.
•
Position the handlebar as shown. Fit the mounting
components and tighten the knob lightly.
components and tighten the knob lightly.
•
Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that
the machine is in a comfortable working position when
it hangs from the harness.
support hook. Now make a final adjustment so that
the machine is in a comfortable working position when
it hangs from the harness.
H1155734-26,524L,525LST,RJD,.fm Page 12 Friday, March 8, 2013 7:19 AM