Husqvarna 525RX 用户手册

14 – English

•

Remove the mounting plate (H). Fit the adapter (I) and 
bracket (J) with the two screws (K) as shown. Fit the 
blade guard (A) to the adapter using the 4 screws (L) 
as shown.

CAUTION!  Use the recommended blade guard. See 
the Technical data section.

•

Fit the drive disc (B) on the output shaft.

•

Turn the output shaft until one of the holes in the drive 
disc aligns with the corresponding hole in the gear 
housing.

•

Insert the locking pin (C) in the hole to lock the shaft.

•

Place the blade (D) and support flange (F) on the 
output shaft.

•

Fit the nut (G). The nut must be tightened to a torque 
of 35-50 Nm (3.5-5 kpm). Use the socket spanner in 
the tool kit. Hold the shaft of the spanner as close to 
the blade guard as possible. To tighten the nut, turn 

the spanner in the opposite direction to the direction 
of rotation (Caution! left-hand thread). 

•

When loosening and tightening the saw blade nut, 
there is a risk of injury from the teeth of the saw blade. 
You should therefore always ensure that your hand is 
shielded by the blade guard when doing this. Always 
use a socket spanner with a shaft that is long enough 
to allow this. The arrow in the diagram shows the area 
where you should operate the socket spanner when 
loosening or tightening the nut.

•

Fit the trimmer guard/combination guard (A) intended 
for use with the trimmer head/plastic blades. Hook the 
guard onto the fitting on the shaft and secure it with 
the bolt (L). 

•

Fit the drive disc (B) on the output shaft.

•

Turn the output shaft until one of the holes in the drive 
disc aligns with the corresponding hole in the gear 
housing.

•

Insert the locking pin (C) in the hole to lock the shaft.