Husqvarna 525RXT 用户手册

English

 –

 27

The air filter must be regularly cleaned to remove dust 
and dirt in order to avoid:

•

Carburettor malfunctions

•

Starting problems

•

Loss of engine power

•

Unnecessary wear to engine parts.

•

Excessive fuel consumption.

Clean the filter every 25 hours, or more regularly if 
conditions are exceptionally dusty.

Close the choke control by setting the choke into a choke 
position.

Remove the air filter cover and take out the filter. Wash it 
clean in warm, soapy water. Clean also the inside of the 
filter cover by using air or a brush. Ensure that the filter is 
dry before refitting it. 

Remove the Felt filter from the filter holder and gently 
brush debris from the filter. Check the rubber sealing 
surface. Change the filter on the rubber seal if damaged.

An air filter that has been in use for a long time cannot be 
cleaned completely. The filter must therefore be replaced 
with a new one at regular intervals. A damaged air filter 
must always be replaced. Damaged, very dirty, or fuel-
soaked air filter must always be replaced.

The bevel gear is filled with the right quantity of grease at 
the factory. However, before using the machine you 
should check that the bevel gear is filled three-quarters 
full with grease. Use HUSQVARNA special grease.

The grease in the bevel gear does not normally need to 
be changed except if repairs are carried out.

The drive shaft end in the lower shaft should be lubricated 
with grease every 30 hours. There is a risk that the drive 
shaft ends (splined coupling) on models with two-piece 
shafts will seize if they are not lubricated regularly.