Husqvarna SPM1702SM 用户手册
10 –
English
ASSEMBLY
Fitting the loop handle
(325Cx)
•
Position the handle on the shaft. Note that the handle
must be mounted below the arrow on the shaft.
must be mounted below the arrow on the shaft.
•
Fit the screw, securing plate and wing nut as shown in the
diagram.
diagram.
•
Tighten the wing nut.
Fitting the loop handle
(323L, 323LD, 325Lx, 325LDx)
•
Clip the loop handle onto the shaft. Note that the loop
handle must be fitted between the arrows on the shaft.
handle must be fitted between the arrows on the shaft.
•
Slide the spacer into the slot in the loop handle.
•
323L/323LD: Fit the nut, washer and screw.
325Lx/325LDx: Fit the nut, knob and screw. Do not
overtighten.
overtighten.
•
Now adjust the trimmer to give a comfortable working
position. Tighten the bolt/knob.
position. Tighten the bolt/knob.
Assembling and dismantling the
two-piece shaft
two-piece shaft
(323LD, 325LDx)
Assembly:
•
Loosen the coupling by turning the knob.
•
Align the tab of the attachment (A) with the arrow on the
coupling (B).
coupling (B).
•
Push the attachment into the coupling until the attachment
snaps into place.
snaps into place.
•
Before using the unit, tighten the knob securely.
Dismantling:
•
Loosen the coupling by turning the knob (at least 3 times).
•
Push and hold the button (C). While securely holding the
engine end, pull the attachment straight out of the
coupling.
engine end, pull the attachment straight out of the
coupling.
A
B
C