Husqvarna 143R-II 用户手册
ASSEMBLY
English
–
13
and the cable position keep 1-2mm play between the
cable lug and the slotted fitting when the throttle
trigger is fully depressed.
cable lug and the slotted fitting when the throttle
trigger is fully depressed.
7
When the throttle cable is adjusted correctly, tighten
the lock-nut (F) and the M3 screw (G).
the lock-nut (F) and the M3 screw (G).
8
Plug the stop switch wires (H) into the matching
connectors from the engine. Note that wire polarity is
not important.
connectors from the engine. Note that wire polarity is
not important.
9
Lap and fix the stop switch wires and connectors with
clamp (I).
clamp (I).
10 Fit the dust cover (J).
11 Refit the air filter cover.
Fitting blades and trimmer heads
1-2mm
!
WARNING!
When fitting the cutting attachment it is
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
extremely important that the raised
section on the drive disc/support flange
engages correctly in the centre hole of
the cutting attachment. If the cutting
attachment is fitted incorrectly it can
result in serious and/or fatal personal
injury.
!
WARNING! Never use a cutting
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
IMPORTANT! If a saw blade or grass blade are to be
used the machine must be equipped with the correct
handlebar, blade guard and harness.
used the machine must be equipped with the correct
handlebar, blade guard and harness.