Ryobi RY30520 用户手册

下载
页码 26
21
MAINTENANCE
CLEANING THE EXHAUST PORT AND 
MUFFLER
Depending  on  the  type  of  fuel  used,  the  type  and 
amount of oil used, and/or your operating conditions, the  
exhaust  port,  muffler,  and/or  spark  arrestor  screen  may 
become  blocked  with  carbon  deposits.  If  you  notice  a 
power loss with this gas-powered product, you may need 
to remove these deposits to restore performance. We highly 
recommend that only qualified service technicians perform 
this service.
SPARK ARRESTOR
The spark arrestor must be cleaned or replaced every 25 
hours or yearly to ensure proper performance of the product. 
Spark arrestors may be in different locations depending on 
the model purchased. Please contact the nearest service 
dealer for the location of the spark arrestor for this model. 
REPLACING AND CLEANING AIR FILTER
See Figures 28 - 29.
A wet or dirty air filter can affect the way the engine starts, 
performs, and wears. The air filter should be checked and 
cleaned after 5 hours of operation. For best performance, 
the air filter should be replaced once each year.
To clean the air filter:
  Loosen the knob on the air filter cover.
  Remove the cover.
  Lift the edge of the air filter carefully and peel it out.
  Wash the air filter with warm, soapy water.
  Rinse and squeeze to dry.
  Reinstall the air filter.
  NOTE: Make sure the filter is seated properly inside the 
cover. Installing the filter incorrectly will allow dirt to enter 
the engine, causing rapid engine wear.
�  Reinstall the cover.
  Tighten knob to secure.
FUEL CAP
WARNING:
A leaking fuel cap is a fire hazard and must be replaced 
immediately.
The fuel cap contains a non-serviceable filter and a check 
valve.  A  clogged  fuel  filter  will  cause  poor  engine  perfor-
mance. If performance improves when the fuel cap is loos-
ened, check valve may be faulty or filter clogged.  Replace 
fuel cap if required.
SPARK PLUG REPLACEMENT
This  engine  uses  a  Champion  RCJ-6Y  or  NGK  BPMR7A 
spark  plug  with  .025  in.  electrode  gap.  Use  an  exact  re-
placement and replace annually.
Fig. 28
AIR FILTER COVER
AIR FILTER
  Fig. 29
AIR FILTER 
BASE
STORAGE (1 MONTH OR LONGER)
  Drain  all  fuel  from  tank  into  a  container  approved  for 
gasoline. Run engine until it stops.
  Clean all foreign material from the trimmer. Store idle unit 
indoors in a dry, well-ventilated area that is inaccessible 
to children. Keep away from corrosive agents such as 
garden chemicals and de-icing salts.
  Abide by all ISO and local regulations for the safe storage 
and handling of gasoline. 
AIR FILTER 
COVER
KNOB
PULL COVER 
TO OPEN