Land Pride RCR1260 用户手册
10
Section 1: Assembly & Set-up
RCR1248, RCR1260 and RCR1272 Rotary Cutter 326-047M
12/15/15
Driveline Installation
Refer to Figure 1-3 & Figure 1-4:
The cutter driveline is coupled to the tractor PTO shaft
with a push pin coupler and to the implement shaft with
either a shear bolt or bolt on slip clutch for protection from
shock loads. Always engage PTO at low engine rpm to
minimize start-up torque. Drivelines with friction slip
clutches must go through a “run-in” operation prior
to initial use and after long periods of inactivity. See
“Clutch Run-In” on page 21 for detailed instructions on
maintaining the slip clutch.
with a push pin coupler and to the implement shaft with
either a shear bolt or bolt on slip clutch for protection from
shock loads. Always engage PTO at low engine rpm to
minimize start-up torque. Drivelines with friction slip
clutches must go through a “run-in” operation prior
to initial use and after long periods of inactivity. See
“Clutch Run-In” on page 21 for detailed instructions on
maintaining the slip clutch.
!
DANGER
!
DANGER
!
WARNING
!
WARNING
!
WARNING
IMPORTANT: An additional driveline may be
required if cutter is to be used on more than one
tractor, especially if a Quick Hitch is used.
required if cutter is to be used on more than one
tractor, especially if a Quick Hitch is used.
The driveline must be lubricated before putting it into
service. Refer to “Lubrication Points” on page 25.
service. Refer to “Lubrication Points” on page 25.
Shear Bolt Protected Driveline
Figure 1-3
Slip Clutch Protected Driveline
Figure 1-4
Implement End
Tractor End
Push Pin Coupling
Bolt-on Yoke with
Shear Bolt Protection
30292
Implement End
Tractor End
Push Pin Coupling
Bolt-on Yoke with Slip
Clutch Protection
30293