Land Pride RCM4015 用户手册

10/21/15

7.

Be sure both sides are equal distance from ground to 
continuous hinges and that left and right leveling rods 
have equal tension. Re-tighten jam nut (#3).

Refer to Figure 2-4:
Each wing section will need adjusting if wing top is not 
level with center deck top when wings are unfolded.

1.

With tractor hydraulics, lower wings down. Refer to 
“Field Set-up” on page 31 for instructions on how to 
lower wings.

2.

Pull cutter straight forward six to ten feet to allow 
outer wing wheels to properly align themselves. 

3.

Check wing tops to see if they are level with the top of 
the center deck. If the outer edge of either wing top is 
higher or lower than the center deck, then that wing 
should be leveled as follows:

a. If outer wing edge is higher than the center 

deck, loosen jam nut (#1) & rotate turnbuckle (#2) 
clockwise to lower outer wing edge until wing is 
level. Tighten jam nut (#1) to the correct torque 
when level.

b. If outer wing edge is lower than the center deck, 

loosen jam nut (#1) and rotate turnbuckle (#2) 
counterclockwise to raise outer wing edge until 
wing is level. Tighten jam nut (#1) to the correct 
torque when level.

27926

27857