Husqvarna 966529103 用户手册

11

OPERATION

TIPS FOR IMPROVED BAGGING

Follow the mower operation instructions in the mower 
operator’s manual.
When operating your grass catcher on a lawn where 
grass and leaf bagging equipment has not been 
used, you are picking up thatch and debris that has 
accumulated for long periods of time. The amount 
collected and the total time of operation may be 
greater than you will experience with regular use of 
your grass catcher.

•  Always run throttle at full speed when bagging.
•  Select a speed low enough to give good mower 

cutting performance, good quality cut and good 
bagging performance.

•  If grass is extremely tall, it should be mowed 

twice. The first time relatively high, the second 
time to desired height.

•  Use left hand side of mower for trimming.
•  Plastic trash bags (3.0 mil, 30 gallon) can be 

inserted inside grass catcher containers for ease 
of debris disposal. To remove the plastic trash 
bags when full:

 

a.  Disengage blades, shift into neutral, engage 

the parking brake and stop the engine.

 

b.  Unlatch and raise cover.

 

c.  Remove one container at a time by grasping 

container handles and pulling toward the rear, 
off of the tube rails.

 

d.  With the container resting on the ground, 

close and secure the top of the plastic lawn 
bag.

 

e.  Tip the container on its side and slide the 

filled bag from the container.

 

f.  Install a new plastic lawn bag with the edges 

of the bag draped over upper lip of the 
container.

 

g.  Repeat for other container.

 

h.  Reinstall containers making sure right 

container overlaps left container at center 
supports.

 

i.  Close cover and secure latches over center 

support tubes.

•  Avoid cutting wet grass or in the morning while 

the dew is still heavy. Grass clippings collected 
under these conditions tend to be sticky and 
adhere to the walls of the flow path causing 
clogging.

•  If the grass catcher fails to pick up cut grass 

or leaves, it is an indication that clogging has 
occurred in the system or that the grass catcher 
containers are full.

 

a.  Disengage blades, place motion control 

levers in neutral position.

 

-  Unlatch and raise cover.

 

-  Slide out containers and dispose of 

clippings.

 

-  Replace containers, close cover, and 

latch.

 

b.  Unlatch chutes and check for clogging.

 

-  Remove all debris in chute.

 

-  Reassemble and latch chutes.

GENERAL RECOMMENDATIONS

Always observe safety rules when performing any 
maintenance.

•  Before each use check for loose fasteners.
•  Clean unit thoroughly after each use.

For best results mower blades must be kept sharp. 

Replace bent or damaged blades.

•  See BLADE CARE instructions in your mower 

operator’s manual.

STORAGE

When grass catcher is to be stored for a period of 
time, clean it thoroughly, remove all dirt, grass, leaves, 
etc. Store in a clean, dry place.