Husqvarna CA 150 用户手册

 

10 – 

 

English

 

The bevel gear is filled with the right quantity of grease at the 
factory. However, before using the machine you should check 
that the bevel gear is filled three-quarters (40g) full with 
grease. Use HUSQVARNA special grease.

CAUTION! The gear housing must not be filled completely 
with grease. The grease expands as the machine heats up 
during operation. If the gear housing was completely filled 
with grease it could damage the seals and lead to leakage of 
grease.

The grease in the bevel gear does not normally need to be 
changed except if repairs are carried out.

 

Loosen the split pin and cotter pin.

Remove the tine unit from the angle gear’s output axle.

Loosen the 3 screws holding the tine.

Replace the tine with a new and assemble in the reverse 
order.

 

Below you will find some general maintenance instructions. If 
you need further information please contact your service 
workshop.

 

1

Check that the guard is undamaged and not cracked. 
Replace the guard if it has been exposed to impact or is 
cracked.

2

Check that the blades do not move when the engine is 
idling or when the choke is in the start throttle position.

3

Check that the tines are undamaged and show no signs of 
cracking or other damage. Replace the tines if necessary.

 

1

Check that the bevel gear is filled three-quarters (40g) full 
with lubricant. Fill if necessary using special grease.

1

2

3

1