Ryobi Outdoor RY60511A 用户手册

14

15

When  servicing,  use  only  identical  Ryobi  replacement 
parts.  Use  of  any  other  parts  may  create  a  hazard  or 
cause product damage.

Always wear safety goggles or safety glasses with side 
shields  during  power  tool  operation  or  when  blowing 
dust. If operation is dusty, also wear a dust mask.

Before inspecting, cleaning or servicing the machine, shut 
off engine, wait for all moving parts to stop, and discon-
nect spark plug wire and move it away from spark plug. 
Failure to follow these instructions can result in serious 
personal injury or property damage.

Avoid  using  solvents  when  cleaning  plastic  parts.  Most 
plastics are susceptible to damage from various types of 
commercial solvents and may be damaged by their use. Use 
clean cloths to remove dirt, dust, oil, grease, etc.

Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact 
with  plastic  parts.  Chemicals  can  damage,  weaken  or
destroy  plastic  which  may  result  in  serious  personal 
injury.

Only the parts shown on the parts list are intended to be 
repaired or replaced by the customer. All other parts should 
be replaced at a Ryobi Authorized Service Center.

See Figure 19.
A wet or dirty air filter can affect the way the engine starts, 
performs, and wears. 

cleaned after 8 hours of operation. If working in dusty soil, 
check the air filter after each refueling. 
For best performance, the air filter should be replaced once 
each year.
To clean the air filter:
n 

Loosen the knob on the air filter cover.

n 

Remove the cover.

n 

Lift the edge of the air filter carefully and peel it out.

n 

Wash the air filter with warm, soapy water.

n 

Rinse and squeeze to dry.

n 

Reinstall the air filter. 

 

NOTE:  Make sure the filter is seated properly inside the 
cover. Installing the filter incorrectly will allow dirt to enter 
the engine, causing rapid engine wear.

n 

Reinstall the cover.

n 

Tighten knob to secure.

Fig. 19

See Figure 20.
The cultivator uses NGK BPMR7A or Champion RCJ-6Y spark 
plug. Use an exact replacement and replace annually.
n

 

Remove the spark plug boot.

n

 

Loosen the spark plug by turning it counterclockwise with 
a socket.

n

 

Remove the spark plug.

n

 

Hand thread the new spark plug, turning it clockwise.

n

 

Tighten with a socket and torque to 170 in. lb. minimum, 
190 in. lb. maximum. Do not overtighten.

Be  careful  not  to  cross-thread  the  spark  plug.  Cross-
threading will seriously damage the product.

Fig. 20