Exabyte 1X7 LTO 用户手册
O
CTOBER
2006
M
AGNUM
1
X
7 LTO A
UTOLOADER
135
T
APE
A
LERT
F
LAGS
Drive CMD Error
The tape drive received an invalid
command.
1.
If possible, use the operator panel to
unloaded any cartridge that is in the
).
2.
Power the autoloader off and back on
to reset the tape drive.
3.
If the error persists, contact Exabyte
Technical Support (see
) or your
service provider.
Drive Load Fail
The cartridge couldn’t be loaded
into the tape drive because of a
mechanical problem or because of a
broken tape.
1.
Export the tape from the autoloader
) and verify that it is in
good condition, then retry the
operation.Replace the cartridge if
necessary.
2.
If the error persists, contact Exabyte
Technical Support (see
) or your
service provider.
Drive Timeout
The tape drive took too long to load
or unload a tape, or the tape drive is
not responding.
1.
If possible, use the operator panel to
unloaded any cartridge that is in the
).
2.
Power the autoloader off and back on
to reset the tape drive.
3.
If the error persists, contact Exabyte
Technical Support (see
) or your
service provider.
Drv Unload Fail
The cartridge couldn’t be unloaded
from the tape drive because of a
mechanical problem.
1.
Power the autoloader off and back on
to reset the tape drive.
2.
Retry the unload operation once.
3.
If the error persists, contact Exabyte
Technical Support (see
) or your
service provider.
H/W Inoperable
An operation couldn’t be completed
because of a mechanical problem.
1.
Reset the autoloader and retry the
operation.See
for reset
instructions.
2.
If the error persists, contact Exabyte
Technical Support (see
) or your
service provider.
Hardware Error
An operation couldn’t be completed
because of a mechanical problem.
1.
Reset the autoloader and retry the
operation.See
for reset
instructions.
2.
If the error persists, contact your service
provider.
Table C-1 Autoloader error messages (continued)
Error Message
Description
Corrective Action