Exabyte 1X7 LTO 用户手册

1012581

Insert an M5 screw (A) through a second screw hole (B) and engage the 

pem nut on the second screw hole in the rail flange (C). If necessary, use a 

washer. Finger-tighten the screw.

3.

3.

3.

3.

Adjust the length of the rail assembly as necessary to fit the depth of the 

rack (E).

4.

4.

4.

4.

Back of rack—Make sure the rail assembly is level, then use M5 screws (A) 

to attach the back flange (D) of the rail to the inside of the rack, using the 

same procedure as step 2. If your rack has square mounting holes or the 

holes are much larger than the screws provided in the kit, use a washer. 

Finger-tighten the screws. 

5.

5.

5.

5.

Using a #2 Phillips screwdriver, tighten the screws securing the rails to the 

front and back of the rack.

6.

6.

6.

6.

Using a #2 Phillips screwdriver, tighten the four screws holding the rail 

assembly together.

7.

7.

7.

7. Right side rail assembly

—Repeat steps 1 through 6 for the right-side rail 

assembly. Make sure that the right rail assembly is at the same level as the 

left rail assembly.

To attach the autoloader to the rails:

1.

1.

1.

1.

From the front of the rack, place the autoloader onto the shelf created by the 

rails (see 

2.

2.

2.

2.

Slide the autoloader all the way back until it makes contact with the small 

flanges near the back of the rails (see 

).