Snapper 1721301-02 用户手册
11
Initial Setup & Assembly
INITIAL SETUP & ASSEMBLY
NOTE: Some of the following setup procedures may
already be completed.
already be completed.
Assemble Blade
1. Place the blade on a flat surface.
2. See Figure 10. Install one bar stop (A) using the two
5/16-18 x 1 taptite screws (B). Do not install second
bar stop.
bar stop.
3. See Figure 11. Insert threaded end of eyebolt (A)
through lug on blade, and screw on 5/16 nut (B) just
far enough so that it is flush with the end of the eye-
bolt.
far enough so that it is flush with the end of the eye-
bolt.
4. See Figure 11. Hook the springs (C) into the pivot
frame (D). Using a pliers, stretch the springs to hook
the opposite ends to the eyebolts (A).
the opposite ends to the eyebolts (A).
5. See Figure 11. Tighten the nut (B) on each eyebolt
enough to expose about 3/4" (19 mm) of thread.
6. See Figure 11. Holding the first nut (B) with a
wrench,add a second nut (E) to each eyebolt, and
tighten securely against the first nut to act as a jam
nut.
tighten securely against the first nut to act as a jam
nut.
Assemble & Install Hitch
1. See Figure 12. Assemble the spring-assist bracket
(A) to the hitch assembly (E). Secure with capscrew,
lockwasher, and nut.
lockwasher, and nut.
Figure 10. Bar Stop
A. Bar Stop
B. Taptite Screw, 5/16-18 x 1
A. Bar Stop
B. Taptite Screw, 5/16-18 x 1
Figure 11. Tension Springs
A. Eyebolt
A. Eyebolt
D. Pivot Frame
B. Nut, 5/16
E. Nut, 5/16
C. Spring
Figure 12. Spring Assist Bracket
A. Spring Assist Bracket
B. Capscrew, 1/2-13 x 1-1/4
C. Lockwasher, 1/2
D. Hex Nut, 1/2-13
E. Hitch
A. Spring Assist Bracket
B. Capscrew, 1/2-13 x 1-1/4
C. Lockwasher, 1/2
D. Hex Nut, 1/2-13
E. Hitch
B
D
C
A
E