Husqvarna O0803001 用户手册
16
TIPS FOR IMPROVED BAGGING
Follow the mower operation instructions in you
mower operator’s manual.
mower operator’s manual.
When operating your grass catcher on a lawn where
grass and leaf bagging equipment has not been
used, you are picking up thatch and debris that has
accumulated for long periods of time. The amount
collected and the total time of operation may be
greater than you will experience with regular use of
your grass catcher.
grass and leaf bagging equipment has not been
used, you are picking up thatch and debris that has
accumulated for long periods of time. The amount
collected and the total time of operation may be
greater than you will experience with regular use of
your grass catcher.
•
Always run throttle at full speed when bagging.
•
Select a speed low enough to give good mower
cutting performance, good quality cut and good
bagging performance.
cutting performance, good quality cut and good
bagging performance.
NOTE: It may be necessary to overlap width
of cut to suit your conditions.
of cut to suit your conditions.
•
If grass is extremely tall, it should be mowed
twice. The fi rst time relatively high, the second
time to desired height.
twice. The fi rst time relatively high, the second
time to desired height.
•
Use left hand side of mower for trimming.
•
Plastic trash bags (3.0 mil, 30 gallon) can be
inserted inside grass catcher containers for ease
of debris disposal. To remove the plastic trash
bags when full:
inserted inside grass catcher containers for ease
of debris disposal. To remove the plastic trash
bags when full:
a. Disengage blades, shift into neutral, engage
the parking brake and stop the engine.
b. Unlatch and raise cover.
c. Remove one container at a time by grasping
container handles and pulling toward the
rear, off of the tube rails.
rear, off of the tube rails.
d. With the container resting on the ground,
close and secure the top of the plastic lawn
bag.
bag.
e. Tip the container on its side and slide the
fi lled bag from the container.
f. Install a new plastic lawn bag with the edges
of the bag draped over upper lip of the
Container (for replacement bags refer to
REPLACEMENT PARTS).
Container (for replacement bags refer to
REPLACEMENT PARTS).
g. Repeat for other container.
h. Reinstall containers making sure right
container overlaps left container at center
supports.
supports.
i.
Close cover and secure latches over center
support tubes.
support tubes.
CAUTION
• DO NOT operate mower with grass catcher
partially installed.
• Disengage blades and stop engine before
leaving mower seat to empty containers,
unclogging chutes, etc.
unclogging chutes, etc.
• Close cover before starting.
• Disengage mower blades when crossing
• Disengage mower blades when crossing
driveways or gravel surfaces and other
areas where thrown objects could be a
hazard.
areas where thrown objects could be a
hazard.
• DO NOT attempt to vacuum cans or other
potentially hazardous projectiles.
•
Avoid cutting wet grass or in the morning while
the dew is still heavy. Grass clippings collected
under these conditions tend to be sticky and
adhere to the walls of the fl ow path causing
clogging.
the dew is still heavy. Grass clippings collected
under these conditions tend to be sticky and
adhere to the walls of the fl ow path causing
clogging.
•
If the grass catcher fails to pick up cut grass
or leaves, it is an indication that clogging has
occurred in the system or that the grass catcher
containers are full.
or leaves, it is an indication that clogging has
occurred in the system or that the grass catcher
containers are full.
a. Disengage blades, place motion control
levers in neutral position.
- Unlatch and raise cover.
- Slide out containers and dispose of
clippings.
- Replace containers, close cover, and
latch.
b. Unlatch chutes and check for clogging.
- Remove all debris in chute.
- Reassemble and latch chutes.
OPERATION