Poulan 954 14 00-50 用户手册

14

On some model tractors, it may be necessary to drill new 
holes in drawbar for the mounting bracket. To determine if 
you need to drill holes in your drawbar, closely look at the 
illustration below.

Your drawbar may or may not have some or all of the holes 
shown. For the assembly of your new grass catcher only the 
fi ve holes dimensioned will be used. If your drawbar does 
not have the fi ve holes in the correct po si tions continue 
with this section.
1.   Remove the drawbar by removing the two mounting 

bolts on each side. Keep hardware for remounting. 

NOTE: If your tractor has a wire loop mounted to the draw-
bar, remove it at this time.

2.    Place the drawbar in a vice or similar locking device.
3.    Cut out the 4 hole bolt pattern template from the back 

of this manual.

4.    Align top and right edge of template and drawbar.
5.    Tape in position.
6.    Mark and drill hole #1 only, using a 11/32" drill bit.
7.    Assemble mounting bracket to drilled hole in drawbar 

with one hex bolt and nut from hardware group "B". 

NOTE: Mounting bracket must be assembled with lanced 
tabs to bottom as shown.

8.     Align bracket so it is parallel with right edge of drawbar 

and tighten securely. Holes in bracket should line up 
with remaining holes in template.

9.    Using bracket as a template, drill remaining three (3) 

11/32"  mounting holes.

NOTE: If your tractor is equipped with a wire loop, drill new 
mounting hole as shown, if necessary.
10. For ease of assembly mounting bracket should be 

assembled at this time (refer to "REAR MOUNTING 
BRACKET" in ASSEMBLY section of this manual).

11.  Remount  drawbar to tractor using hardware previously 

removed. 

NOTE:  Failure to reconnect the wire loop connection will 
result in not being able to start tractor.

02350

02349

1-1/8"

2-3/4"

2-1/4"

3-3/8"

2"

1-7/16"

02348