Poulan CG46A 用户手册

7

1.    Rotate cover assembly onto its side as shown.

2.      Secure support tubes to cover assembly using short hex 

bolts, long hex bolts, and locknuts as shown.  Tighten 
all hardware securely. 

020

86

0235

7

1.   Install support plate to inside of drawbar as shown, 

using two (2) 7/16-14 x 3/4 hex bolts and the two 
threaded upper holes in the plate.  Do not tighten at 
this time. 

NOTE:  Be sure to align the four (4) lower threaded holes 
of the support plate with the holes in the drawbar.

2.      Assemble the mounting bracket as shown to the out side 

of the drawbar using four (4) 7/16-14 x 3/4 hex bolts 
and the four (4) lower threaded holes of the support 
plate.  Tighten all hard ware securely.

1.    Align mark on seal with mark at cover opening.

2.   Work seal into opening so cover sits between fl anges 

of seal.

023

56