Scag Power Equipment SWU 用户手册

SWU99AG

Figure 2. "Adjust-A-Grip"

Cutting conditions will determine what setting is needed

for the Adjust-A-Grip" and your machine. If the drive

belts slip due to high moisture conditions, the tension may

need to be increased. On the other hand, if the day is

dry and you are cutting on flat terrain the tension may be

decreased. To change the settings:

1. Pull back and move the lever up to reduce tension

on the drive belt.

2. Pull back and move the lever down to increase

tension on the drive belt.

ADJUSTING CUTTING HEIGHT

The mower deck can be adjusted from a height of

1-inch to 4-1/2 inches at 1/2-inch intervals. To adjust the

cutting height:

Do not adjust the cutting height with the mower
blades rotating. Shut off the engine and remove
the ignition key. Bodily injury could occur from
the rotating blades. Lift cutter deck by the handles
only. Do not reach under the cutter deck to lift it.

1. Shut off the engine and remove the ignition key.

2. Remove the two hairpins from the adjusting pins on

one side of the cutter deck (Figure 3).

3. Using the deck handles, lift or lower the deck to the

desired cutting height and reinstall the hairpins. A

deck height decal is located on the deck mounting

frame as an aid in adjusting the deck to the desired

height.

4. Repeat the above process on the other side of the

cutter deck.

Figure 3. Cutting Height Adjustment

CUTTER BLADES

Do not sharpen beyond 1/3 of the width of the blade.

(See Figure 3)

-NOTE-

Dress the blade with a file. Using a wheel

grinder may burn the blade. Check the balance

of the blade. If blades are out of balance,

vibration and premature wear of spindle assem-

bly can occur. See your authorized Scag dealer

for blade balancing or special tools if you

choose to balance your own blades.

Figure 4. Blade Sharpening

SC4O8G

ANGLE BLADE BACK

DO NOT CUT IN

X MUST NOT EXCEED

1/3 BLADE WIDTH

WARNING:

Remove Hair Pins

2K SWU DHA

Lift deck with
handles only