Weed Eater 96024000100 业主指南

RIDING MOWER
Always observe safety rules when performing

any maintenance.
BRAKE OPERATION
If riding mower requires more than four (4)

feet to stop at highest speed in highest gear

on a level, dry concrete or paved surface, then

brake must be serviced. (See “TO ADJUST

BRAKE” in the Service and Adjustments

section of this manual).
TIRES
• Maintain proper air pressure in all tires

(See PSI on tires).

• Keep tires free of gasoline, oil, or insect

control chemicals which can harm

rubber.

• Avoid stumps, stones, deep ruts, sharp

objects and other hazards that may cause

tire damage.

NOTE: To seal tire punctures and prevent

flat tires due to slow leaks, tire sealant may

be purchased from your local parts dealer.

Tire sealant also prevents tire dry rot and

corrosion.

AXLE AND SPINDLES
• Front wheel axles and front spindles should

be properly lubricated.

• Wheel Axles should be lubricated with a

dry, powdered graphite type lubricant.

• Spindles should be lubricated with a spray

type silicone base lubricant.

Wheel Axle

Spindle

02828

ROS "ON" Position

Engine "ON" Position

(Normal Operating)

OPERATOR PRESENCE SYSTEM AND

REVERSE OPERATION SYSTEM (ROS)
Be sure operator presence and reverse

operation systems are working properly.

If your riding mower does not function as

described, repair the problem immediately.

• The engine should not start unless the

brake pedal is fully depressed, and the

deck clutch lever is in the disengaged

position.

CHECK OPERATOR PRESENCE

SYSTEM
• When the engine is running, any at-

tempt by the operator to leave the seat

without first setting the parking brake

should shut off the engine.

• When the engine is running and the

deck clutch lever is engaged, any at-

tempt by the operator to leave the seat

should shut off the engine.

• The deck clutch lever should never operate

unless the operator is in the seat.

CHECK REVERSE OPERATION (ROS)

SYSTEM
• When the engine is running with the

ignition switch in the engine "ON" posi-

tion and the deck clutch lever engaged,

any attempt by the operator to shift into

reverse should shut off the engine.

• When the engine is running with the

ignition switch in the ROS "ON" posi-

tion and the deck clutch lever engaged,

any attempt by the operator to shift into

reverse should NOT shut off the engine.

BLADE CARE
For best results mower blades must be

sharp. Replace worn, bent or damaged

blades.

CAUTION:

Use only a replacement

blade approved by the manufacturer of

your riding mower. Using a blade not ap-

proved by the manufacturer of your riding

mower is hazardous, could damage your

riding mower and void your warranty.