Woods Equipment 872502G 用户手册

A turnbuckle-style hydrostat neutral adjustment is 
provided.  

Neutral:  

1.   Support the machine with the rear wheels off 

the ground.  Use jackstands or equivalent sup-
port.  Do not rely only on mechanical or hydraulic 
jacks.  

2.   Move the traction levers out into the neutral lock 

position and raise the seat.

3.   Disconnect the seat switch wire K and 

temporarily connect the two terminals with 
jumper wire J as shown. 

4.  Start the engine and run at low speed.  
5.  Loosen jam nuts T at both ends of the control 

rod.  

6.   Rotate the control rod until the corresponding 

wheel stops turning.  Lock the jam nuts.  Run the 
engine up to high idle to check the adjustment.  
Readjust if necessary.  

7.  Repeat steps 5 and 6 for the opposite side.
8.  Remove the jumper wire J and reconnect the 

seat switch.

1.  Move traction levers out to the neutral lock posi-

tion and raise the seat.

2. Locknut 

U should be run on the bolt as far as it 

will go.

3.  Loosen jam nut Y.  Adjust the clevis yoke by 

turning the head of the bolt until the clevis pin 
just makes contact with the rear of the slot in the 
lever it connects with.  Tighten jam nut Y.

4.  Repeat steps 2 and 3 for the opposite side.

NOTE:  A slight creep in reverse is acceptable 
provided the wheel does not turn and the hydrostat 
pump does not whine when the parking brake is on.