Stiga 46 ELECTRIC 用户手册

Always mow so the cable is laid out behind you on 
the grass (fig. 6).

Before mowing the lawn, take care to remove any 
stones toys and other hard objects.

A machine with MULTICLIP system cuts the 
grass, chops it finely and then blows it down in the 
lawn. The grass clippings need not to be collected.

The following rules should be observed to give 
best MULTICLIP effect:

1. Do not cut the grass too short. Not more than 1/

3rd of the length should be cut off.

2. Always keep it clean under the mower casing.

3. Always use a well sharpened blade.

4. Avoid mowing when the grass is wet. The grass 

then sticks to the underside of the casing, giving 
poor mowing results.

The cutting height can be adjusted to 4 positions by 
moving the wheel axles (fig. 7).

Position 1 = Lowest cutting height
Position 4 = Highest cutting height

In order to function properly the engine must be ef-
fectively cooled. This is done by a fan which sucks 
in air at the air intake on the engine casing (fig. 8).

To make sure that the cooling system functions 
properly the air intake must be thoroughly cleaned 
if it has become blocked.

The machine should be cleaned each time after 
use. For best possible mowing results it is impor-
tant that the underside of the chassis is kept clean. 
Use a brush or blow with compressed air.

The machine must not be washed down with water.

You must never service the motor or the lawn 
mower before first shutting off the motor and pull-
ing out the plug.

Use protective gloves to prevent cuts when chang-
ing blades/knifeblades.

Blunt and damaged blades tear off the grass and 
spoil the look of the lawn after mowing. New, well 
sharpened blades cut the grass cleanly, so that the 
lawn looks green and fresh even after mowing.

To replace the cutting blades, slacken the screw us-
ing the enclosed blade wrench. Fit the new blade 
so that the punched STIGA logotype on the blade 
is facing upwards towards the chassis (not down 
towards the grass). Refit the screw and tighten to 
20 Nm.

When replacing the blade, the blade screw should 
also be replaced.

The guarantee does not cover damage to the blade, 
blade holder or engine caused by running into ob-
stacles.

When replacing the blade, the blade holder and 
blade screw, always use original spare parts. Non-
authentic spare parts could lead to the risk of per-
sonal injury or damage, even if they fit the ma-
chine.

Sharpening of the blades must be done by wet 
method grinding, using a whetstone or a grind-
stone.

For the sake of safety, the blades should not be 
sharpened on an emery wheel. A very high temper-
ature could cause the blade to become brittle.

Thoroughly clean the mower and store it indoors in 
a dry place.