Stiga 125 COMBI PRO 用户手册

The following symbols appear on the machine. 
They are there to remind you of the care and atten-
tion required in use.

This is what the symbols mean:

Warning!
Read the instruction manual and the safety 
manual before using the machine.

Warning!
Do not insert your hands or feet under the 
cover when the machine is in operation.

Warning!
Watch out for discarded objects. Keep on-
lookers away.

Warning!
Before starting repair work, remove the 
spark plug cable from the spark plug.

Warning!
To minimise the risk of tipping 
over, frame weights should be in-
stalled on the machine when using 
the cutting deck.

The cutting deck is available as standard in two 
versions:
- with mechanical setting of the cutting height 
(item no. 13-2936).
- with factory-fitted, electrical setting of the cut-
ting height (item no. 13-2937).

1. Install the deck mounts on the machine’s steer-
ing knuckles (fig. 1). 

2. Place the cutting deck in front of the machine.

3. Remove the pins (fig. 2).

4. Screw the cutting deck into the deck mounts 
(fig. 3).

5. 13-2937:
Connect the electrical contact to the socket on the 

side of the machine (fig. 4).

6. Set the maximum cutting height.

7. Force the V-belt onto the machine’s centre pul-
ley A (fig. 5). 

8. Lift the rear edge of the cutting deck and secure 
with the pins (fig. 2). The basic setting for ma-
chines with 17“ tyres is position 3.

9. Tension the belt with the belt idler B. The belt 
idler should be on the left side of the belt viewed 
from the driver’s position (fig. 5). 

10. Secure the lift spring’s snap hook in the imple-
ment lifter (fig. 6). The position of the snap hook 
can be varied by threading it into different links in 
order to achieve better lifting height or to follow 
the ground better. 

11. Secure the S-hook to one of the inner holes on 
the implement lifter.

In order for the deck to cut evenly and attractively, 
it has to be correctly adjusted: 

1. Make sure the air pressure in the tyres is correct:
Front: 0.6 bar (9 psi).
Rear: 0.4 bar (6 psi). 

2. Place the machine on a level floor. Undo the 
pins (fig. 2). 

3. Adjust the deck so that the front and rear edge of 
the cover are the same height above the floor. 

4. Secure with the pins. 

Your new cutting deck combines two different 
functions in the same product:

1. “MULTICLIP”
The machine comes equipped with a plug installed 
in the ejector opening (fig. 7). The cutting deck can 
be used for “Multiclip” i.e. the blade finely cuts up 
the grass during mowing. The grass then falls into 
the lawn where it is allowed to rot. This provides 
the lawn with nourishment. 
To remove the plug, the cutting deck must first be 
folded up into the service position (see heading 
SERVICE POSITION). Then unscrew the plug.