Alamo Eagle 14 用户手册

Eagle 20   03/09

Operation Section 4-49

© 2009 Alamo Group Inc.

Excessive Vibrations

Check Gear box bolts.

Tighten if loose.

Check For loose nuts on

Tighten If loose

bladeholder and blades

Check for bent output shaft.

Replace shaft if bent.

If shaft is bent oil will normally

leak from the bottom seal.

Check to see if blades are .

Free blades so they swing

free swinging.

Check for even wear on each .

Weigh blades. Weight should be 

blade tip. Were both blades 

within 1 oz. Always replace both blades

changed at the same time.

Blade Broken.

Replace blades, in sets.

Blade carrier bent.

Replace carrier.

Blade hub not properly 

Remove hub, check tapered spline

seated on shaft

shaft, clean and replace.

New Blade or bolts matched

Replace blades or bolts in sets

Drivelines not phased

Replace Drivelines.

Gearbox Overheating

Low on lubricant.

Fill to level plug.

Improper type lubricant.

Replace with proper lubricant.

Excessive trash build-up .

Remove trash.

around gear box 

Bearing or gears set up improperly

Consult your dealer.

Gearbox Noisy 

Rough gears.

Run in or change gears.

Worn bearing.

Replace bearing

Gear Box Leaking

Damaged oil seal

Replace Seal.

Bent shaft.

Replace oil seal and shaft.

Shaft rough in oil seal area.

Replace or repair shaft.

Oil seal installed wrong.

Replace seal.

Oil seal not sealing in the housing.

Replace seal or use a sealant 

on OD of seal.

Oil level too high.

Drain oil to proper level.

Sand hole in casting.

Replace castings or gear box.

Gasket damaged.

Replace gasket.

Bolts loose.

Tighten bolts.