Husqvarna TS300-E3 用户手册

NOTE: You may now roll or drive your tractor off the skid. 

Follow the ap pro pri ate instruction below to remove the 

tractor from the skid.

  WARNING: Before start ing, read, un der stand and fol low 

all in struc tions in the Op er a tion section of this man u al. Be 

sure tractor is in a well-ventilated area. Be sure the area in  

front of tractor is clear of other peo ple and objects.

•  Raise attachment lift lever to its highest po si tion.
•  Release parking brake by depressing clutch/brake 

ped al.

•  Place gearshift lever in neutral (N) po si tion.
•  Roll tractor forward off skid.

 WARNING: Before starting, read, un der stand and follow 

all in struc tions in the Operation section of this manual. Be 

sure tractor is in a well-ventilated area. Be sure the area in  

front of tractor is clear of other people and objects.
• 

Be sure all the above assembly steps have been com-

 plet ed.

•  Check engine oil level and fill fuel tank with gasoline.
• 

Sit on seat in operating position, depress clutch/brake 

pedal and set the parking brake.

•  Place gear shift lever in neutral (N) position.
• Raise 

at 

tach ment lift lever to its highest position.

•  Remove key from bag and start the engine (see "TO 

START ENGINE" in the Operation section of this 

manual). After engine has started, move throttle control 

to idle (slow) position.

• 

Depress clutch/brake pedal into full "BRAKE" position 

and hold. Move gearshift lever to 1st gear.

•  Slowly release clutch/brake pedal and slowly drive 

tractor off skid.

• 

Apply brake to stop tractor, set parking brake and place 

gearshift lever in neutral position.

•  Turn ignition key to "STOP" position.
Continue with the instructions that follow.

• 

Remove bolt and flat washer se cur ing seat to cardboard 

packing and set aside for as sem bly of seat to tractor.  

Remove the cardboard packing and discard.

•  Connect switch to seat.
•  Place seat on seat pan so all three (3) bottom pads 

are positioned over large slotted holes in pan.

Grasp adjustment handle and pull up, slide seat to desired 

po si tion and release adjustment handle.

•  Push down on seat to engage pads in slots and pull 

seat towards rear of tractor.

•  Raise seat and tighten bolt securely.
•  Remove tape and discard.
•  Lower seat into operating position and sit on seat. 

Press clutch/brake pedal all the way down. If operating 

position is not comfortable, adjust seat.