Husqvarna 968999658 用户手册

English

-

59

Engine Oil filter
1.  Drain the engine oil in accordance with the work 

description under the heading Engine Oil/Change 

Engine Oil. 

2.  Remove the oil filter. If necessary, use a filter 

remover.

3.  Wipe new, clean engine oil onto the seal for the 

new filter.

4.  Mount the filter by hand with + ¾ turn.
5.  Run the engine warm, then check that there are no 

leaks around the oil filter seal.

6.  Check the oil level in the engine, fill if necessary. 

The oil filter holds 0.1 qt (0.1 liters) of oil.

(Transmission)
This transaxle is designed with an external filter for 

ease of maintenance. To ensure constant fluid quality 

levels and longer life an oil filter change interval of 

every 200 hours is recommended.

The following procedure can be performed with the 

transaxles installed in the vehicle, and the vehicle 

on level ground. Apply the bypass valve for each 

transaxle and lock the vehicle parking brake.

1.  Remove the three ¼" filter guard screws and filter 

guard. Clean any loose debris from around the 

perimeter of the filter. See illustrations.

2.  Place an oil drain pan (12" or more diameter and 

8 qt. capacity is optimal) beneath the oil filter. 

Remove the oil filter from the transaxle.

3.  After the oil has drained, wipe the filter base 

surface off and apply a film of new oil to the gasket 

of the new replacement filter.

4.  Install the new filter by hand, turn ¾ to one full 

turn after the filter gasket contacts the filter base 

surface.

5.  Re-install the filter guard with the three ¼" screws. 

Torque screws to 65 in/lbs. each.

6.  Repeat steps on the opposite side of transaxle 

drive.

8011-734

8019-011-1

1. Filter (guard removed)

1