Husqvarna WHF5223 / 966947006 用户手册

oPERATIoN

24 - Husqvarna

8062-011

8062-012

Observe and mark rocks and other fixed objects in 

• 

order to avoid collisions.
Properly level the cutting deck for best mowing 

• 

performance. The blades should be parallel to the 

ground or slightly tipped down in the front.
Use only sharp blades.

• 

Check tire pressure. Different pressure can cause 

• 

uneven mowing results.
Use the left hand side of the deck for trimming.

• 

mow so clippings are discharged onto the area 

• 

that has been cut. Have the cut area to the 

right of the mower. This will result in more even 

distribution of clippings and a more uniform cut. 

To avoid clippings spraying on roads etc, mow the 

first two patterns in opposite direction.
Begin with a high cutting height and reduce it until 

• 

the desired mowing result is attained.
Cut the average lawn to 2½" (64 mm) during the 

• 

cool season and to over 3" (76 mm) during the hot 

months. For healthier and better looking lawns, 

mow often after moderate growth.
For best cutting performance, grass over 15 cm 

• 

(6") in height should be mowed twice. make the 

first cut relatively high; the second to the desired 

height.
Use a high engine speed (the blades rotate 

• 

rapidly) and low ground speed (the machine 

moves slowly) for the best mowing results. If the 

grass is not too long and dense, the ground speed 

can be increased without noticeably depreciating 

the mowing result.
Mow often to obtain the finest lawn. Mowing 

• 

becomes more even and grass clippings more 

evenly distributed over the mown area. The total 

time taken is not increased, as a higher driving 

speed can be used without inferior mowing results.
Avoid mowing wet lawns. The mowing result is 

• 

inadequate because the wheels sink into the soft 

lawn. Clumps build and the grass clippings will 

fasten under the cowling.
Hose the mower deck with water after each use. 

• 

Hose especially underneath. Do not spray high 

pressure spray directly on top of spindles. Avoid 

getting engine too wet.
Do not spray water directly on a hot mower. Allow 

• 

it to cool to a safe temperature before cleaning.