Husqvarna YTH18542 用户手册

Adjust the mower while tractor is parked on level ground 
or driveway.  Make sure tires are properly infl ated (See 
“PROD UCT SPECIFICATIONS” section of this manual).   If 
tires are over or underinfl ated, you will not properly adjust 
your mower.

MENTS:
 •  Depress clutch/brake pedal fully and set parking brake.
 •  Place motion control lever in neutral (N) position.
 •  Place attachment clutch  in “DISENGAGED” position.
 •  Turn ignition key  to “STOP” and remove key.
 •  Make sure the blades and all moving parts have completely stopped.
 •  Disconnect spark plug wire from spark plug and place wire where it cannot come in contact  
 with 

Mower will be easier to remove from the right side of 
tractor.
•     Place attachment clutch switch in “DISENGAGED” 

po si tion.

•      Move attachment lift lever forward to lower mower to 

its lowest position.

•      Roll belt off electric clutch pulley.
•     Disconnect anti-sway bar from chassis bracket by 

re mov ing re tain er spring.

•      Disconnect suspension arms from rear deck brackets 

by removing retainer springs.

•      Disconnect front links from deck by removing retainer 

springs.

•      Raise lift lever to raise suspension arms. Slide mower 

out from under tractor.

IMPORTANT:  If an attachment other than the mower deck 
is to be mounted on the tractor, remove the front links.

•      Raise attachment lift lever to its highest position.
•      Slide mower under tractor with defl ector shield to right 

side of tractor.

•      Lower lift lever to its lowest position.
•     Connect front links to mower deck and secure with 

retainer springs..

•     Connect suspension arms to rear deck brackets and 

secure with retainer springs.

•     Connect anti-swaybar to chassis bracket and secure 

with retainer spring.

•      Install belt into electric clutch pulley groove.