Husqvarna 966947008 用户手册

lUBRICATIoN

38 - Husqvarna

If possible, grease both ends of the cables and move 

the controls to end stop positions when lubricating. 

Refit the rubber covers on the cables after lubrication. 

Cables with sheaths will bind if they are not lubricated 

regularly. If a cable binds, it can disrupt operation.
If a cable binds, remove the cable and hang it 

vertically. lubricate it with light engine oil until the oil 

begins to escape from the bottom.
Tip: Fill a small plastic bag with oil and tape it so that 

it seals against the sheath and allow the cable to hang 

vertically from the bag overnight. If you do not succeed 

in lubricating the cable, it must be replaced.

lubricate with a grease gun, one zerk for each wheel 

mount, until the grease is forced out. Use only good 

quality bearing grease. Grease from well-known brand 

names (petrochemical companies) usually maintains a 

good quality. 

lubricate with a grease gun, one zerk for each set of 

wheel bearings, until the grease is forced out. Use only 

good quality disulphide grease.

8062-029

lubricate the cable ends at the carburetor with the oil 

can. move the controls to the end points and lubricate 

again.  

The throttle cable is also lubricated at the control when 

the control console is removed.

8011-605