Husqvarna GT48XLSi 用户手册

*Pedal

(2) Screw

(2) Nut

U-Channel

*Installed by Dealer

*Brush Guard Kit

Slope Sheet

(1) Quick Connect

(1) Oil Drain Tube

Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping purposes.

ADJUST SEAT (See Fig. 2)

• Sit in seat.
•

Lift up adjustment lever (A) and slide seat until a com-

fortable position is reached which allows you to press

clutch/brake pedal all the way down.

• Release lever to lock seat in position.

Fig. 2

NOTE: You may now roll your tractor off the skid. Continue

using the instructions that follow to remove the tractor from

the skid.

WARNING: Before start ing, read, un der stand and fol-

low all in struc tions in the Op er a tion section of this man u al.

Ensure tractor is in a well-ventilated area. Ensure the area

in front of tractor is clear of other peo ple and objects.

TO ROLL TRACTOR OFF SKID

(See

Op er a tion section for location and function

of con trols)

•  Raise attachment lift lever to its highest po si tion.
•  Release parking brake by de press ing brake ped al.
•  Place freewheel control in dis en gaged po si tion to

dis en gage trans mis sion (See “TO TRANS PORT” in

the Op er a tion section of this manual).

• Roll tractor forward off skid.
Continue with the in struc tions that follow.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Stan dard

wrench sizes are listed.
(1) 1/2" wrench

Tire pressure gauge

(2) 7/16" wrenches

Utility knife

Pliers

When right or left hand is mentioned in this man ual, it means

when you are in the operating po si tion (seated be hind the

steer ing wheel).

Fig. 1

LABEL

TO CHECK BATTERY (See Fig. 1)

• Lift hood to raised position.
NOTE: If this battery is put into service after month and

year indicated on label (label is located between terminals)

charge battery for minimum of one hour at 6-10 amps.

(See "BATTERY" in Maintenance section of this manual

for charging instructions).
• For battery and battery cable installation see "RE-

PLACING BATTERY" in the "Service and Adjustments"

section in this manual.

ASSEMBLY

UNASSEMBLED PARTS

TO REMOVE TRACTOR FROM CARTON

UNPACK CARTON

• Remove all accessible loose parts and parts cartons

from carton.

• Remove end panels and lay side panels flat.
• Check for any additional loose parts or cartons and

remove.

BEFORE REMOVING TRACTOR FROM

SKID