Husqvarna GTH2248XP 用户手册

The gauge wheels are designed to keep the mower deck 
in proper position when operating mower. Be sure they 
are properly adjusted to ensure optimum mower per for -
mance. 
•      Slide gauge wheel bar down into bracket channel, Be 

sure that gauge wheel bar aligning holes are on top. 
As sem ble gauge wheels as shown using shoulder bolts, 
3/8 washers and 3/8-16 center locknuts and tighten 
securely.

•     For ease of mower to tractor assembly, raise gauge 

wheels to highest position and retain with clevis pins 
and spring retainers.

•         Adjust gauge wheels before operating mower. See “TO 

ADJUST GAUGE WHEELS” in the Operation sec tion 
of this manual.

•      Press lift lever plunger and raise attachment lift lever 

to its highest po si tion.

•      Release parking brake by depressing brake ped al.

•     Place freewheel control in free 

wheel ing po 

si tion to 

dis en gage transmission (See “TO TRANSPORT” in 
the Operation section of this manual).

•      Roll tractor forward off skid.

  WARNING:  Before start ing, read, un der stand and fol low 

all in struc tions in the Op er a tion section of this man u al. Be 
sure tractor is in a well-ventilated area. Be sure the area in  
front of tractor is clear of other peo ple and objects.
•      Be sure all the above assembly steps have been com-

pleted.

•      Check engine oil level and fi ll fuel tank with gasoline.
•     Place freewheel control in "transmission engaged" 

po si tion.

•      Sit on seat in operating position, depress brake pedal 

and set the parking brake.

•      Press lift lever plunger and raise attachment lift lever 

to its highest position.

•         Start the engine. After engine has started, move throttle 

control to idle position.

•      Release parking brake.
•      Slowly move the mo tion control lever for ward and slowly 

drive tractor off skid.

•      Apply brake to stop tractor and set parking brake.
•      Turn ignition key to "OFF" position.
Continue with the in struc tions that follow.

02521

Seat position should be adjusted forward or backward so 
that the operator can comfortably reach clutch/brake pedal 
and safely operate the tractor.  
•     Remove the two (2) bolts and fl at washers securing 

the seat to cardboard packing. Keep the two (2) bolts 
only and place them with the two (2) identical bolts 
and four (4) washers in the parts bag. Discard the fl at 
washers and cardboard packing.

•      Release L.H. seat slide  on seat pan by pulling out on 

adjustment handle and sliding it to the rear position 
exposing seat mount ing holes from bot tom. Slide R.H. 
slide to same rear position.

•      Mount rear of seat on slides using mount ing bolts and 

lock washers as shown. 

•         Pull out on adjustment handle and slide seat all the way 

forward. Install front mounting bolts and lock washers. 
Tight en all mounting bolts securely.

•         Lower seat into operating position and sit on seat. Press 

clutch/brake pedal all the way down. If operating posi-
tion is not comfortable, adjust seat.

•      To adjust seat: Grasp adjustment handle and pull out, 

slide seat to desired po si tion and release adjustment 
handle.

NOTE: You may now roll or drive your tractor off the skid. 
Follow the appropriate instruction below to remove the 
tractor from the skid.