Husqvarna GTH2254XP 用户手册

TO REPLACE HEADLIGHT BULB

• Raise hood.
• Pull bulb holder out of the hole in the backside of the

grill.

• Replace bulb in holder and push bulb holder securely

back into the hole in the backside of the grill.

• Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.
• Check wiring. See electrical wiring diagram in the

Repair Parts section.

TO REPLACE FUSE

Replace with 30 amp automotive-type plug-in fuse. The
fuse holder is located behind the dash.

SERVICE AND ADJUSTMENTS

02141

HEADLIGHT
WIRE
CONNECTOR

FIG. 30

HOOD

TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 30)

•      Raise hood.
•      Unsnap headlight wire connector.
•         Stand in front of tractor. Grasp hood at sides, tilt toward

engine and lift off of tractor.

• To replace, reverse above procedures.

TERMINAL
GUARD

TERMINAL
ACCESS
DOOR

FIG. 29

0217

HEX
BOLT

KEPS NUT

POSITIVE
(RED)
CABLE

NEGATIVE
(BLACK)
CABLE

ENGINE

TO AD JUST THROTTLE CON TROL CABLE

The throttle control has been preset at the factory and
ad just ment should not be necessary. If adjustment is nec-
es sary, see engine manual.

TO AD JUST CHOKE CON TROL

The choke control has been preset at the factory and ad-
just ment should not be necessary. If adjustment is neces-
sary, see engne manual.

TO ADJUST CARBURETOR

Your carburetor is not adjustable. If your engine does not
operate properly due to suspected carburetor problems,
take your tractor to an authorized service center for repair
and/or adjustment.