Husqvarna EZF 3417/ 965879301 用户手册

English

MAINTENANCE

V-belts

Deck belt
Inspect every 50 hours of operation. Check for severe

cracking and large nicks.

NOTE: The belt will show some small cracks in

normal operation.

Belt tension is manually adjustable. Turn bolt on deck

eyebolt to adjustment tension.

NOTE: Belt deflection or movement should be

approximately ¼" (6mm) when measured at

midpoint between pulleys. Periodically inspect

both belt and idler systems.

Adjusting belt tension

front deck

Tension

Eyebolt

Deck belt removal

1. Park on a level surface. Apply parking brake.
2. Lower the deck into the lowest cutting

position.

3. Remove bolts from belt shields and remove

shields.

4. Remove any dirt or grass that may have

accumulated around the cutter housings and

entire deck surface.

5. Release idler pulley tension.
5. Carefully roll the belt over the top of the

cutter housing pulleys and remove belt.

Deck belt installation

NOTE: For ease in installing the deck belt, refer to

the routing decal on bottom of seat.

Wrap the deck belt around the electric clutch

pulley that is located on the engine shaft.

Route the belt forward and up onto the deck.

Place belt around spring loaded idler pulley.

Double check belt routing to make sure it

matches the routing decal, and the belt does

not have any twist. Correct as needed.

Adjust tension with deck eyebolt.

Replace belt shields on both mandrel

housings and secure with fasteners.

front deck2

1. Shield bolts
2. Belt shields
Removing deck belt

8011-773

1. Clutch pulley
2. Deck belt
Belt routing, deck belt