Husqvarna 966659502 用户手册

MAINTENANCE

39

Check every 100 hours of operation. Check for severe 
cracking and large nicks.
NOTE: The belt will show some small cracks in normal 
operation.
The belts are not adjustable. Replace belts if they 
begin to slip from wear.

Deck Belt Removal
1.  Park on a level surface. Apply parking brake.
2.  Lower the deck into the lowest cutting position.
3.  Remove bolts from belt shields and remove 

shields.

4.  Remove any dirt or grass that may have 

accumulated around the cutter housings and 
entire deck surface.

5.  Remove tension on the belt by moving the idler 

arm.

6.  Carefully slip belt up over the top of the cutter 

housing pulleys and remove belt. Rolling belt over 
the pulleys may damage the belt.

1.  Wrap the deck belt around the electric clutch 

pulley that is located on the engine shaft.

2.  Route the belt forward and up onto the deck.
3.  Place belt around spring loaded idler pulley.
4.  Wrap the belt around the stationary idler pulley 

and around the mandrel housings.

5.  Push inward on the idler arm and carefully route 

belt over stationary idler pulley. Once belt is 
properly routed, slowly release idler arm to tension 
belt.

6.  Double check belt routing to make sure it matches 

the routing decal, and the belt does not have any 
twist. Correct as needed.

7.  Replace belt shields on both mandrel housings 

and secure with fasteners.

8011-764

8058-088