Husqvarna 445e 用户手册

34 – English

recoil spring by letting the pulley rotate slowly 
backwards.

•

Undo the bolt in the centre of the pulley and remove 
the drive disc (A), drive disc spring (B) and the pulley 
(C). Insert and secure a new starter cord in the starter 
pulley. Wind approx. 3 turns of the starter cord on the 
starter pulley. Fit the starter pulley so that the end of 
the recoil spring (D) hooks into the starter pulley. Now 
assemble the drive disc spring, drive disc and the bolt 
in the centre of the pulley. Carry the starter cord 
through the hole in the starter housing and the starter 
handle. Tie a good knot on the starter cord.

•

Hook the starter cord in the notch in the pulley and 
turn the starter pulley about 2 turns clockwise.

Note! Check that the pulley can be turned an 
additional 1/2 turn when the starter cord is pulled all 
the way out.

Stretch the line with the handle. Move your thumb and 
release the line. See the figure below.

•

Lift up the starter pulley. See instructions under the 
heading Changing a broken or worn starter cord. 
Remember that the recoil spring is coiled under 
tension in the starter housing.

•

Remove the cassette with the recoil spring from the 
starter.

•

Lubricate the recoil spring with light oil. Fit the 
cassette with recoil spring in the starter. Fit the starter 
pulley and tension the recoil spring.

•

Undo the bolt in the centre of the pulley and remove 
the drive disc and the drive disc spring.

•

Replace the drive disc spring and fit the drive disc 
above the spring.