Husqvarna 230 ACX 用户手册
English - 19
3. INSTALLATION
The charging station must be positioned on relatively
level ground. The height difference must not differ
more than 5 cm between the front and rear of the
charging station.
level ground. The height difference must not differ
more than 5 cm between the front and rear of the
charging station.
The charging station must not be positioned so that
its plate bends.
its plate bends.
Consider the distance to a wall socket when choosing
the position. The charging station should be
connected to a 230V wall socket via the low voltage
cable and transformer.
the position. The charging station should be
connected to a 230V wall socket via the low voltage
cable and transformer.
The supplied low voltage cable is 20 metres long.
Tip!
It is possible to let the low voltage cable cross
the working area. It must then be either stapled down
or buried. In some cases there is a better positioning
option for the charging station than close to a house
wall or by the closest wall socket.
or buried. In some cases there is a better positioning
option for the charging station than close to a house
wall or by the closest wall socket.
The transformer must be placed where it is well
ventilated and is not exposed to direct sunlight. It is
also beneficial if the transformer can be placed under a
roof.
ventilated and is not exposed to direct sunlight. It is
also beneficial if the transformer can be placed under a
roof.
It is recommended to use an earth fault-breaker when
connecting the transformer to the wall socket.
connecting the transformer to the wall socket.
Do not put the charging station in a corner or pocket
in the working area.
in the working area.
IMPORTANT INFORMATION
The low voltage cable must not be extended.
3012-554
3012-532
3012-220
3012-223
3012-223
3012-513