Husqvarna 216 用户手册

16 – 

English

•

Localise and mark stones and other fixed objects to avoid 
collision.

•

Start with a high cutting height and reduce down until the 
required mowing results are obtained.

•

The mowing result will be best with the highest permitted 
engine speed, see technical data, (the blades rotate 
rapidly) and low speed (the Mower moves slowly). If the 
grass is not too high and thick, the driving speed can be 
increased without noticeably depreciating the mowing 
result.

•

The best lawns are achieved if the grass is cut often. 
Mowing becomes more uniform and the grass cuttings 
become more evenly distributed over the surface. The 
total time consumption is not greater since it is possible to 
select a higher driving speed without inferior mowing 
results.

•

Avoid mowing a wet lawn. The mowing results are inferior 
since the wheels sink down into the soft lawn.

•

Hose down the cutting unit with water underneath each 
time it is used. The cutting unit should then be put in the 
service position.

•

When the BioClip function is used, it is very important that 
the mowing interval is not too long.

Preferably allow the engine to idle for a minute to obtain 
normal working temperature before stopping it if it has been 
working hard. Avoid idling the engine for long periods, as 
there is a risk of carbon build-up on the spark plugs.

1

Lift up the cutting unit by pulling the lever backwards to its 
locked position.

1

 Pull back the throttle and turn the ignition key to the 
”STOP” position.

2

When the Rider is at a standstill, press down the parking 
brake and push in the locking button.

WARNING! Do not use the machine on 
ground that slopes more than 10°°°°.... Mow 
slopes upwards and downwards, never 
across. Avoid sudden changes in direction.

S

TO

P

STA

RT