Husqvarna GTH2754 用户手册

SERVICE AND ADJUSTMENTS

FIG. 18

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER VICE OR AD JUSTMENTS:

•

Depress brake pedal fully and set parking brake.

•

Place attachment clutch in “DISENGAGED” position.

•

Turn ignition key to “STOP” and remove key.

•

Make sure the blades and all moving parts have completely stopped.

•

Disconnect spark plug wire from spark plug and place wire where it cannot come in contact

with

plug.

TO REMOVE MOWER (See Fig. 18)

•      Place attachment clutch in “DIS EN GAGED” position.
•      Lower attachment lift lever to its lowest position.
•      Disengage belt tension rod from lock bracket.

CAUTION: Belt tension rod is spring
loaded. Have a tight grip on rod and
release slowly.

• Remove mower belt from electric clutch pulley.
• DISCONNECT REAR MOWER PINS Pull out the spring

loaded pin, disconnect suspension arm from pin and
release pin.

• Go to other side of mower and disconnect rear pin in

the same manner.

02786

REAR MOWER
PINS

FRONT PLATE
ASSEMBLY

ELECTRIC CLUTCH
PULLEY

BELT TENSION
ROD
DISENGAGED
POSITION

LOCKING BRACKET

FLANGED PINS

DOUBLE LOOP
RETAINER SPRINGS

SUSPENSION ARMS

SINGLE LOOP
RETAINER SPRINGS

• Remove the four retainer springs and two fl anged pins

from front plate assembly and remove plate.

• Raise attachment lift lever to its highest position.
• Turn tractor steering wheel to the left as far as it will

go.

• Slide mower out from under right side of tractor.

TO IN STALL MOWER

Follow procedure described in “INSTALL MOWER AND
DRIVE BELT” in the As

sem bly section of this manual.

NOTE: You will need to reattach front plate assembly to
tractor after sliding mower under the tractor.

TRACTOR