Husqvarna 320 AWD 用户手册

English

 – 19

•

If necessary, the wires can be adjusted by tightening the 
adjuster nuts on each side of the steering collar. Do not 
over tighten the cables; they should only be drawn in 
towards the steering collar.

Hold the cable, for example using an adjustable wrench, 
so that it does not twist.

If the adjustment is only made on one side, the middle 
position of the steering will be affected.

Check the wire tension on completion of the adjustment 
as per item 2.

The parking brake is adjusted as follows:

1

Loosen the locking nuts (1).

2

Tension the cable using the adjuster screw (2) until the 
play in the cable is taken up.

3

Tighten the locking nuts (1) after adjustment.

4

The parking brake should be checked again after the 
adjustment has been made.

Check that the parking brake is adjusted correctly by placing 
the machine on a slope with the front and rear axles 
disengaged.

Apply and lock the parking brake. When the machine does not 
stand still, the parking brake should be adjusted according to 
the following.

1

Remove the left-hand wing cover.

2

Loosen the locking nuts (1).

3

Tension the cable using the adjuster screw (2) until the 
play in the cable is taken up.

4

Tighten the locking nuts (1).

5

The brake should be checked again after adjustment

6

Assemble the left-hand wing cover.

The throttle cable may need to be adjusted, if the engine does 
not respond as it should when accelerating, if it produces 
black smoke or maximum revs are not reached.

If doubts arise, contact your service representative.

1

Loosen the clamping screw for the cable’s outer casing 
and move the throttle to the full throttle position.

2

Pull the choke wire casing to the far right and tighten the 
clamping screw.

3

Pull back the throttle to the full throttle position and check 
that the choke is no longer actuated.