Husqvarna CTH1736 用户手册

CONNECT BATTERY (See Fig. 2)

CAUTION: Do not short battery termi-

nals by allowing a wrench or any other

object to con tact both terminals at the

same time. Before connecting battery,

remove metal bracelets, wristwatch

bands, rings, etc.
Positive terminal must be connected

first to prevent sparking from accidental

ground ing.

• If this battery is put into service after month and year

indicated on label (label located between terminals)

charge battery for minimum of one hour at 6-10 amps.

(See "BATTERY" in the Maintenance section of this

manual for charg ing instructions).

•  Remove battery cover.
•  Remove terminal protective caps and discard.
•  First connect RED battery cable to positive (+) ter-

minal with hex bolt and keps nut as shown. Tighten

securely.

• Connect BLACK grounding cable to negative (-) ter-

minal with remaining hex bolt and keps nut. Tighten

securely.

• Replace battery cover.
Open battery cover for:
• Inspection for secure connections (to tighten hard-

ware).

• Inspection for corrosion.
• Testing

battery.

• Jumping (if required).
• Periodic charging .

ASSEMBLY

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Stan dard

wrench sizes are listed.
(2) 7/16" wrenches

Utility knife

(1) 3/4" wrenches

Tire pressure gauge

(1) 3/4" socket w/drive ratchet Pliers
When right or left hand is mentioned in this man ual, it means

when you are in the operating po si tion (seated be hind the

steer ing wheel).

TO REMOVE TRACTOR FROM CAR-

TON

UNPACK CARTON

• Remove all accessible loose parts and parts cartons

from carton.

• Cut along dashed lines on all four panels of carton.

Remove end panels and lay side panels flat.

• Check for any additional loose parts or cartons and

remove.

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.

To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use

the correct tools as necessary to insure proper tightness.

FIG. 1

03125

LOWER STEERING SHAFT

STEERING

BOOT

EXTENSION SHAFT

5/16 HEX BOLT

STEERING

WHEEL

INSERT

ADAPTER

LARGE FLAT WASHER

TABS

TAB

SLOTS

5/16 LOCK WASHER

BEFORE REMOVING TRACTOR FROM

SKID

ATTACH STEERING WHEEL (See Fig. 1)

ASSEMBLE EXTENSION SHAFT AND BOOT

• Slide extension shaft onto lower steering shaft.
• Place tabs of steering boot over tab slots in dash and

push down to secure.

INSTALL STEERING WHEEL

•

Position front wheels of the tractor so they are pointing

straight forward.

• Remove steering wheel adapter from steering wheel

and slide adapter onto steer ing shaft ex ten sion.

• Position steering wheel so cross bars are hor i zon tal

(left to right) and slide inside boot and onto adapt er.

• Assemble large flat washer, 5/16 lock washer, 5/16

hex bolt and tighten se cure ly.

• Snap steering wheel insert into center of steer ing

wheel.

• Remove protective materials from trac tor hood and

grill.

IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN

SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS

TO ROLL OFF SKID.